Filling The Water Tank During Use; How To Make Cappuccino - Ariete 1365 Bedienungsanleitung

of the spouts of the fi lter holder . To stop return the handle to the central standby position . The maximum dose for one cup
of espresso is 50 ml .
Warning!
As in professional coffee machines, do not remove the fi lter holder when the brewing is in progress ; danger of burns!
Warning!
Wait about ten seconds after the coffee has been dispensed before removing the fi lter holder ; To remove it, turn it
slowly from right to left so as to prevent splashes or spurts of water or coffee .
When the machine is in standby mode, the light (R) will go on and off periodically, showing the operation of the boiler ther-
mostat, which is keeping the water at the best temperature . It is appropriate, for the fi rst coffee and for the next ones, to start
the coffee brewing when the light is off .
How to make coffee with a pod (MOD. 1366)
To make the coffee with a pod it is necessary to remove the fi lter (A), the silicone disc (B) and the powder coffee dripper
(C) from the fi lter holder (D) .
1 In the fi lter holder (D) insert the pod dripper (F) and the pod fi lter (E) (Fig. 15).
2 Place the pod in the fi lter ring (Fig. 16) .
3 Push the pod towards the bottom of the fi lter with your fi ngers (Fig. 17) .
4 The pod must be well centred and placed inside the fi lter .
5 Now it is possible to put the fi lter holder in its seat . Tighten the fi lter holder while making sure you have hooked it properly
onto the fl ange (Fig. 8) .
6 The pod could remain stuck in the upper part of the machine after making the coffee and when removing fi lter holder . To
remove it, tilt the fi lter holder (Fig. 18) so the pod can fall onto it .
In order to always get an excellent cup of coffee, buy the pod that bears the E.S.E. compatibility mark .
If the pod is not inserted well, or if the fi lter holder is not tightened fi rmly, a few drops of water could leak from the
fi lter holder .

Filling the water tank during use

It is recommended to fi ll the water tank before it is completely empty .
Turn off the machine . Unplug it from the socket-outlet . Remove the tank . Fill the tank up to the "MAX" mark with cool tap
water . Place the tank on the machine making sure it is securely inserted in and turn it on again .
In the event that the tank remained completely without water, it can happen that air enters the circuit preventing the fl ow of
coffee . To reactivate the machine it will be necessary to turn it off and let it cool . Place a container under the coupling seat
of the fi lter holder and turn on the machine by immediately turning the knob (Q) to the coffee position ( ) .
Drain at least a cup of water from the coupling seat of the fi lter holder to reactivate the hydraulic circuit . Stop the draining
returning the knob (Q) to the central standby position . At this point the machine will resume normal operation .

HOW TO MAKE CAPPUCCINO

Turn the knob (Q) to the steam dispensing position (
(G), Fig. 10. Wait for the steam ready light (r) to turn on.
In the steam waiting phase small puffs of steam may be released from the fl ange of the fi lter holder, this phenome-
non is perfectly normal .
Hold down the button (P) : fi rst a bit of water will come out and immediately after a steam jet whose intensity increases within
a few seconds .
Release the button (P) . Place the jug of milk to whip under the foam accessory .
Immerse the whip to the bottom the milk jug (Fig. 11) and press the button (P) again to obtain the desired result . During
these operations you may notice that the warning light (R) goes on and off from time to time, indicating that the boiler ther-
mostat is keeping the water required for the steam supply at the right temperature . Release the button (P) . Turn the knob
(Q) in central standby position to terminate the steam dispensing .
It is opportune you start dispensing the steam only when this indicator lamp is off . Dispense the steam for a few
seconds after every use in order to free the hole of any milk residue .
USEFUL TIPS FOR PREAPARING A GOOD ITALIAN ESPRESSO
The ground coffee in the fi lter holder has to be pressed lightly . Whether the coffee is stronger or weaker depends on the
degree the coffee is ground, the quantity put into the fi lter holder and the pressing . Just a few seconds are needed for the
), making sure to place a glass under the Maxi Cappuccino device
13