Vertical Steam Ironing; Steam Burst; Water Spray - Grundig SX 8570 Bedienungsanleitung

OPERATION ______________________________
When setting the temperature of your appliance,
we recommend considering the following table.
Fabric Type Temperature Setting
Synthetic •
•
Silk
••
Wool
Cotton •••
Linen - Jeans MAX
3
I n order to learn the ironing temperature to be
used, check the garment's care label.
4
I f you don't know the fabric of your garment,
first iron a part that is not visible and determine
a correct ironing temperature for it.
5 I n order to prevent shiny stains that may form
on synthetic fabrics or silk, iron on the reverse
side of the fabric. Do not use the spray function
in order to prevent the stain formation.
Steam ironing
1 F ill the water tank
2
S et the desired temperature.
3 P ress the steam trigger
ing ironing.
Note
The device contains an Anti-Drip Sensor. Steam
7
amount is automatically regulated depending
on the temperature level. If temperature is not
high enough, even if the steam trigger
pressed, steam production can be lowered or
even stopped.
22 ENGLISH
to release steam dur-
I
is
I
Vertical steam ironing
Note
Vertical steam ironing can be applied to hang-
7
ing curtains or clothes (suits, jackets and coats).
Caution
Never direct the steam at people or pets.
7
1 B ring the iron in a vertical position and steam
iron the curtains or garments on a hanger
pressing the steam trigger
Steam burst
1
D uring ironing, in order to remove tenacious
creases, you can gain strong steam by pressing
on the steam burst button
5-second intervals.
2 W hen you start to iron, steam burst may not
emit in your first couple of presses. In order to
gain steam burst, the temperature
setting dial should be at ••• or a higher
B
level.
3
Y ou can iron the creased parts of the garments
with the steam power which is obtained by
pressing the steam burst button
ironing. However if this process is maintained
without an interruption, water may also come
from the iron soleplate
Water spray
1
M ake sure there is sufficient water in the water
tank. Spray function can be used in order to re-
move tenacious creases by pressing the spray
button G during dry or steam ironing.
.
I
for 3-4 times with
H
during steam
H
along with the steam.
C