Electrolux ST23013 Benutzerinformation Seite 48

48 www.electrolux.com
Problem
The appliance makes noise
during operation.
The appliance does not
operate.
The lamp does not come
on.
The compressor operates
continuously.
Water collects on the rear
plate of the fridge.
Water collects in the fridge. Make sure that the drain hole is not clogged.
There is water on the floor. The melting water outlet does not flow in the evapo-
The temperature in the ap-
pliance is too cold
The temperature in the ap-
pliance is not sufficiently
cold.
The temperature in the
fridge is not sufficiently
cold.
Possible solution
Some sounds are normal when the appliance is op-
erating. Refer to the leaflet supplied with the appli-
ance.
Make sure that the appliance is activated.
Make sure that the mains plug is connected to the
mains socket.
Do a check and see if there is voltage. Connect a
different appliance to the same mains socket. To re-
pair a mains socket, contact a qualified electrician.
Close and open the door to make sure that the lamp
is not in standby.
The lamp is defective. Replace the lamp.
Set the temperature knob at a lower position.
Make sure that the appliance door is closed.
Make sure not to open and close the appliance door
too frequently.
Make sure not to put hot food in the appliance. Wait
until it becomes cool.
Make sure that the room temperature is not too
warm.
It is normal that this occurs when the automatic de-
frosting operates.
Make sure that food or packaging do not prevent
the water to collect in the water container.
rative tray above the compressor.
Attach the melting water outlet to the evaporative
tray.
Set the temperature knob to a lower position.
Set the temperature knob to a higher position.
Make sure that the appliance door is closed.
Make sure not to put hot food in the appliance. Wait
for the food to become cool.
Make sure that the appliance is not too full.
Make sure that there is cold air circulation.