Connection To An Air Distribution System - Palazzetti ECOFIRE AIR SLIM 7 Anleitung

6.8 CONNECTION TO AN AIR DISTRIBUTION
SYSTEM
(only for ducted models or provided with ducting kit)
Ducted models can be connected to a hot air distribution
system. The pipes used should preferably be circular with
a smooth inner surface and suitably insulated to avoid
heat loss.
kit that are not connected to a hot air distribution
deviate the hot air into the room where the stove is
installed.
D
UCTED STOVES
Using the tool supplied or the air de ector lever (based
on the model), the ow of hot air can be deviated from
the room where the stove is installed to the ducting, and
vice-versa (Fig. 6.5).
To connect the stove to the ducting system, remove the
cap by unscrewing the two fastening screws that secure
the duct closure cap on the rear of the stove.
S
TOVES READY TO FIT A DUCTING KIT
To assemble the ducting kit see the instructions provided
with the kit.
The ow of hot air can be deviated from the room to the
ducting using the tool supplied with the kit to adjust the
de ector control located on the front of the stove.
Fig. 6.5
31
COD. 00477 7260 - 09/2018 - Palazzetti - PN - Italy