Technical Data - Lehmannaudio Traveller Kurzanleitung

42 Traveller
Connect your signal source to the Traveller using a jack cable (3.5 mm). You can use
EN
the input on the front or the back of the device. Connect your active speakers to
the output on the front or back of the device. Now switch on the device and use
the buttons on the front to regulate the volume to the desired level.
3 | Mobile source with option to loop in a second Traveller
In this example, the input signal is transferred to a second Traveller.
1
Connect your mobile source to Traveller 1 using a stereo jack cable (3.5 mm). You
can use the input on the front or the back of the device. Then connect Traveller
1 to Traveller 2. Use the available input on Traveller 1 and one of the inputs on
Traveller 2. Now connect up to three headphones to the available outputs on
Traveller 2 and the available output on Traveller 1. Now switch on the device and
use the buttons on the front to regulate the volume to the desired level.

Technical data

2
Input impedance 47 kohms
Maximum gain 10 dB
Frequency response 20 Hz to 30 kHz (-0.5 dB)
Signal to noise ratio > 95 dB RMS unweighted at gain 0 dB
THD
< 0.02 % at 3 mW, 330 ohms
Channel separation > 80 dB, 10 kHz
Tracking error < 0.3 dB
Output power 12 mW at 330 ohms
≠
120 mW at 33 ohms
≠
Output impedance 3 ohms
Connectors audio each 2 x 3.5 mm minijack Stereo for Line In and
Line Out/Headphone Out
Battery
LiPo 3.7 V, 4,000 mAh
Battery runtime up to more than 20 hours on a single charge
(dependent on volume)
Connection power supply Micro-USB, 500 mA charging rate
Charging time
app. 6 hours (with a 500 mA charging device)
Outer dimensions 80 mm x 90 mm x 25 mm
W x D x H
Weight 196 g netto
Traveller 43
EN