Installation - Lehmannaudio Traveller Kurzanleitung

34 Traveller

Installation

EN
This section tells you about the connections, control elements
and application possibilities of your Lehmannaudio Traveller
headphone amplifier.
1 | Unpacking
After unpacking, inspect the Traveller for possible transport damages. If visible
damages are noted, do not use the device under any circumstances. Contact
your dealer promptly in this case.
Scope of delivery:
Traveller unit
≠
USB charging cable
≠
3.5 mm jack cable
≠
Notice
We recommend keeping all packaging for subsequent shipment.
This avoids transport damage. Do not use 'foam chips' or similar
packaging materials under any circumstances. Otherwise the
device 'shakes down' to the bottom of the package during
transportation and may be damaged!
If the original packaging is no longer available, it is best to use
bubble wrap to generously package the device. The pack the
whole thing into a sturdy cardboard box in addition.
Operating manual
≠
Guarantee certificate
≠
2 | Charging
The Traveller can be charged with any type A USB power supply or USB port on
a computer, with an output capacity of at least 500 mA. A suitable charging
cable is supplied with the device. Please ensure that your power supply/charger
or USB connection on the computer can supply the required current.
It takes 5 to 6 hours in order to charge the battery when it is drained entirely.
Note the safety instructions starting on page 28.
3 | Connecting
You can connect the signal source using the supplied mini jack cable (3.5 mm) on
one of the inputs on the front or back.
You can connect your headphones to one of the outputs on the front or back.
Further information about the connections of the Traveller is found in the
section 'Functional description'.
Traveller 35
EN