Timer; Emergency Operation For Wireless Remote-Controller - Mitsubishi Electric Mr. Slim PKA-RP35HAL Bedienungshandbuch

4. Timer

4.1. For Wired Remote-controller
■
Timer functions are different by each remote controller.
■
For details on how to operate the remote controller, refer to the appropriate operation manual included with each remote controller.

5. Emergency Operation for Wireless Remote-controller

(For PKA-RP·HAL)
When the remote controller cannot be used
When the batteries of the remote controller run out or the remote control-
ler malfunctions, the emergency operation can be done using the emer-
gency buttons.
[Fig. 5-1] DEFROST/STAND BY lamp
Operation lamp
Emergency operation switch (heating)
Emergency operation switch (cooling)
Receiver
10
Fig. 5-1
E.O.
SW
Fig. 5-2
Starting operation
• To operate the cooling mode, press the
seconds.
• To operate the heating mode, press the
seconds.
Stopping operation
• To stop operation, press the
than 2 seconds.
[Fig. 5-2] DEFROST/STAND BY lamp (Orange)
Operation lamp (Green)
Emergency operation switch (cooling/heating)
Receiver
• Each press of the emergency operation switch will toggle the operation
mode.
• Check "COOL/HEAT" with the operation monitor display. (The orange
lamp follows this monitor display for 5 seconds after pressing the
emergency operation switch.)
[Heat pump type]
Cooling Heating
Operation Monitor Display
GREEN ORANGE
○ ○
STOP
● ○
COOL
● ●
HEAT
○ ●
: Turning off : Lighting
Note:
• Details of emergency mode are as shown below.
Operation mode
Set temperature
Fan speed
Airflow direction Horizontal
button for more than 2
button for more than 2
button or the button for more
[Cooling only type]
Stop Cooling Stop
The orange lamp follows the
switch operation as indicated at
the left for 5 seconds, and then it
will return to the normal display.
COOL HEAT
24°C 24°C
High High
Downward 4 (5)