Timer; Emergency Operation For Wireless Remote-Controller (Option) - Mitsubishi Electric PEA-RP200 Bedienungshandbuch

4. Timer

■ Timer functions are different by each remote controller.
■ For details on how to operate the remote controller, refer to the appropriate operation manual included with each remote controller.
4.1. For wireless remote controller
ON/OFF
FAN
MODE VANE
CHECK LOUVER
TEST RUN
SET RESET
AAA
5. Emergency Operation for Wireless Remote-controller (option)
ON/OFF
HEAT
Ⓒ
Ⓓ
Ⓑ
Ⓐ
TEMP
AUTO STOP
①③
AUTO START
h
②
min
CLOCK
AAA
①
②
COOL
1) Set the current time
① Press the CLOCK button using a thin stick and blink the time Ⓐ .
h min
② Press the and button to set the current time.
③ Press the CLOCK button using a thin stick.
2) Set the time to start the unit as follows
① Press the AUTO START button.
• Time can be set while the following symbol is blinking.
On time: Ⓑ START is blinking.
• The start times is displayed at Ⓐ .
h min
② Use the and buttons to set the desired time.
③ To cancel the ON timer, press the
3) Set the time to stop the unit as follows
① Press the AUTO STOP button.
• Time can be set while the following symbol is blinking.
Off time: Ⓒ STOP is blinking.
• The stop times is displayed at Ⓓ .
② Use the h and min buttons to set the desired time.
③ To cancel the OFF timer, press the
4) Changing the set times
AUTO START AUTO STOP
Press the or to cancel the timer and repeat from 2) or 3).
① ON/OFF lamp (lit when unit is operating; unlit when unit is not
operating)
② Emergency operation
In cases where the remote control unit does not operate properly, use
either the COOL or HEAT button on the wireless remote control
signal receiver to toggle the unit on or off. On cooler only units,
pushing the HEAT button toggles the fan on and off.
Pressing the COOL or HEAT button selects the following
settings.
Operation mode
Preset temperature 24 °C/75 °F
Fan speed
AUTO START
button.
AUTO STOP button.
COOL HEAT
24 °C/75 °F
High High
9