Herunterladen Inhalt Inhalt Diese Seite drucken

Peavey IPR 1600 Bedienungsanleitung Seite 18

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 65
Rear Panel
10
9
10
AC POWER INLET:
9
This is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the line cord to this
connector to provide power to the unit. Damage to the equipment may result if improper line voltage is used.
(See line voltage marking on unit).
Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not
have a ground pin, a suitable grounding adapter should be used and the third wire should be grounded
properly. To prevent the risk of shock or fire hazard, always make sure that the amplifier and all associated
equipment is properly grounded.
NOTE: FOR U.K. ONLY
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings
identifying the terminals in your plug, proceed as follows: (1) The wire which is colored green and yellow
must be connected to the terminal which is marked by the letter E, or by the Earth symbol, or colored green
or green and yellow. (2) The wire which is colored blue must be connected to the terminal which is marked
with the letter N, or the color black. (3) The wire which is colored brown must be connected to the terminal
which is marked with the letter L, or the color red.
CHANNEL MODE SWITCH
10
HIGH PASS
This position is used to activate the HIGH PASS filter for the corresponding channel. This Linkwitz -Riley
filter will limit the frequencies sent to the associated amplifier channel to those frequencies above 100 Hz. In
situations where separate subwoofer cabinets are being used, this position would indicate connecting the
mid-high frequency speaker cabinet to the channel associated with the HIGH PASS switch.
FULL RANGE
As the name implies, the Full Range position on this switch allows all frequencies to pass to the amplifier.
Normally used when connecting a full range speaker enclosure to the amplifier's output.
SUBWOOFER
This position is used to activate the LOW PASS filter for the corresponding channel. This Linkwitz-Riley filter
will limit the frequencies sent to the associated amplifier channel to those frequencies below 100 Hz. In
situations where separate subwoofer cabinets are being used, this position would indicate connecting the
subwoofer speaker cabinet to the channel associated with the Subwoofer switch.
18

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ipr 4500Ipr 3000Ipr 6000

Inhaltsverzeichnis