Operation; Cleaning And Care; Descaling - Unold 8250 Bedienungsanleitung

OPERaTIOn

1. Remove the kettle from the base.
2. Press the opening key to the back, the lid
is opening.
3. Fill the kettle with water (minimum
0.5 litres, mark MIN, maximum 1.8 litres,
mark MAX).
cautIoN!
If the kettle is overfilled, boiling water may
be ejected!
4. Close the lid until it clicks into place. The
locking prevents accidental opening.
5. Place the kettle level on the base in order
to establish the contact with the power
connection.
6. Switch on the kettle by pressing the ON/
OFF switch downwards into the „I"-position.
The kettle cannot be switched on if it is not
properly seated on the base.
7. Whenever you take the kettle off the base,
the appliance is automatically switched off,
even if the water is not yet boiling.
8. The kettle automatically stops heating at
the latest when the water boils.

CLEanIng anD CaRE

1. Allow the appliance to cool before cleaning it.
2. Before cleaning, always turn off the appliance and
unplug it from the power supply.
3. Do not immerse the base, power cord or
kettle in water or other liquids or wash them
in the dishwasher.
4. Wipe off the base and the kettle with a damp
cloth and a little dishwashing detergent. Do

DESCaLIng

1. The lime scale filter has to be cleaned
regularly. Please empty the kettle completely
and allow it to cool off. Carefully remove the
filter from the pour spout. Clean the filter
carefully with a soft brush under running
water. You can also place the filter in a bowl
with a descaling solution. Then rinse the
filter with clear water and insert it in the
pour spout.
2. To keep the appliance operating efficiently
and to prolong its service life, it should
be descaled regularly, depending on the
hardness of your water.
12
atteNtIoN:
The automatic switch-off only works, if the
lid is correctly closed.
9. Of course you may also push the switch into
the „O"-position to interrupt heating.
cautIoN!
Ensure that the kettle is switched off before
removing it from the base.
10. Please allow the product to cool down for a
certain time before using the kettle again to
heat water.
11. The kettle is fitted with a dry-operation cutout
that switches off the heating elements when
they become too hot, for instance when the
kettle has boiled dry. Allow the kettle to cool
down. Then fill the kettle with cold water.
This will reset the cutout so that the kettle
can be used again.
12. Always use fresh and cold water. Do not
leave water in the kettle.
13. Switch off and unplug electrical appliances
after use.
not use any abrasive scouring agents, steel
wool, metal objects, hot cleaning agents or
disinfectants, since they can damage the
appliance.
5. The appliance must be completely dry on
the outside before you use it again.
3. To descale the kettle, fill it no more than
half full with a solution of half water and
half household vinegar. Bring the liquid to a
boil and leave it in the kettle for a while.
4. Pour the descaling solution out of the
kettle.
5. Then fill it with fresh water and bring to a
boil. Pour this water out as well. Then rinse
the kettle at least twice with clear water.
6. Of course, you can also use commercially
available descaling products; please follow
the instructions on the package.