Philips Mistral Elan HI 272 Gebrauchsanweisung Seite 9

selected, your iron will automatically stop steaming to prevent water
leaking from the sole plate.
When this happens, you can hear "Click". Set the temperature control
to the advised position. Steaming will recommence as soon as the
appropriate temperature has been reached.
• Ensure that there is enough water in the water reservoir.
- Stand the iron on its rear side.
- Set the temperature control at the required position within the "steam
area" (2 or 3) (fig. 6).
- Insert the mains plug into the wall socket.
- Wait a little while for the amber temperature pilot light to go out and to
come on again.
- Set the steam control to the required position (fig. 3).
Ironing without steam
For ironing without steam proceed as described for steam-ironing.
However, the steam control should remain in position O (= no steam).
"Auto stop" (automatic safety shut-off)
(types HI 292 and HI 294 only)
If the iron is left in a motionless horizontal position for more than
30 seconds, or in a vertical position for more than 8 minutes, the red
"Auto Stop" pilot light (N) will start blinking and the heating element will
switch off automatically.
When picking up the iron again, the red light will go out and the amber
temperature pilot light (I) will come on. This indicates that the iron has
begun heating up again.
When the amber indicator light has gone out you can recommence
ironing.
9