Philips Mistral Elan HI 272 Gebrauchsanweisung Seite 11

Cleaning
- Before cleaning remove the mains plug from the wall socket and allow
the iron to cool down sufficiently.
- Scale and other setting can be wiped off the soleplate with a damp
cloth and some non-scratching (fluid) abrasive.
Keep the soleplate smooth: avoid hard contact with metal objects.
- The upper part of the appliance can be cleaned with a damp cloth.
- From time to time clean the inside of the water reservoir by filling with
water and shaking. Then pour the water back out.
Storage
- Remove the mains plug from the wall socket.
- Pour any remaining water out of the water reservoir (fig. 12).
- Set the steam control to position O.
- Stand the iron upright and let it cool down sufficiently.
- The mains cord can be wound around the cord storage.
Allow a generous loop of cord before starting the windings around the
cord storage.
- Always store the iron standing upright (fig. 13).
Regularly check if the mains cord is still in a good and safe condition.
Fitting a different plug
This appliance is fitted with a BS 1363 13 Amp. plug.
Should you need to replace the plug, connect the wires as follows:
Green/yellow wire to the Earth terminal (E) of the new plug.
Brown wire to the Live (L) terminal of the new plug.
Blue wire to the Neutral (N) terminal of the new plug.
Always fit the same value of fuse as that originally supplied with your
appliance.
Only use BS 1362 approved fuses.
As a guide only: Appliances under 700 W can have a 3 Amp. fuse (red)
and all others should have a 13 Amp. fuse (brown).
When disposing of an old plug (particularly the moulded type which has
been cut from the mains cord) always remove the fuse as the plug could
be dangerous if ever inserted in a live socket.
For U.K. only:
11