Startup; Check Connections; Turning On The System; Check Output Values - Balluff BTL5-H1_ _-M_ _ _ _-HC/WC-S94-Serie Betriebsanleitung

BTL5-H1_ _-M_ _ _ _-HC/WC-S94
Micropulse Linear Transducer - Rod Style
5

Startup

5.1

Check connections

Although the connections are polar-
ity reversal protected, components
can be damaged by improper con-
nections and overvoltage. Before
you apply power, check the connec-
tions carefully.
5.2

Turning on the system

Note that the system may execute
uncontrolled movements when first
turned on or when the transducer is
part of a closed-loop system whose
parameters have not yet been set.
6

Versions (indicated on part label)

Supply voltage: 1 = DC 24 V
BTL5-H112-M1000-HC-S94
Nominal length (4 digits):
Transmission speed:
Num. of
Type magnets
1 1
6.1

Included in shipment

Transducer with condensed guide
8
english
Therefore make sure that no haz-
ards could result from these situa-
tions.
5.3

Check output values

After replacing or repairing a trans-
ducer, it is advisable to verify the
values for the start and end position
of the magnet in manual mode. If
values other* than those present
before the replacement or repair are
found, a correction should be made.
* Transducers are subject to modifi-
cation or manufacturing tolerances.
Electr. connections, S94: with connector
Rod Style,
Mounting: HC = metric thread M18x1.5
WC = Thread 3/4"-16UNF
M = metric in mm
0 = 1 MBaud
1 = 800 kBaud
2 = 500 kBaud
PDO1 (Default)
Position, 4 Byte integer
Speed, 2 Byte integer
Cams, 1 Byte integer
6.2

Available lengths

Nominal stroke lengths of from 25
to 4000 mm are available for ide-
ally sizing the transducer to the
application.
3 = 250 kBaud 6 = 50 kBaud
4 = 125 kBaud 7 = 20 kBaud
5 = 100 kBaud 8 = 10 kBaud
PDO2 (Default)
No data mapped
5.4

Check functionality

The functionality of the transducer
system and all its associated com-
ponents should be regularly
checked and recorded.
5.5

Fault conditions

When there is evidence that the
transducer system is not operating
properly, it should be taken out of
service and guarded against unau-
thorized use.
DS 406