Bosch BLR 10 Bedienungsanleitung Seite 20

"Up" and "Down" Direction
Buttons
In the Horizontal Position of the con-
struction laser, the "Up" 4 and "Down" 1
have the following functions:
– With automatic levelling switched on: In
line operation, the aperture angle of the
laser line is increased or decrease in
steps.
Note: The beginning and end points of
a programmable line can be set only by
hand on the construction laser (see the
operating instructions of the construc-
tion laser).
– For single axis inclined operation: The
laser point, laser line or rotational plane
is rotated about the X axis of the con-
struction laser.
– With automatic levelling switched off:
The laser point, laser line or rotational
plane is rotated about the Y axis of the
construction laser.
In the Vertical Position of the construction
laser, the "Up" 4 and "Down" 1 direction
buttons have the following functions:
– With automatic levelling switched on:
The laser point or laser line is rotated in
the rotational plane of the construction
laser.
– With automatic levelling switched off:
The laser point, laser line or rotational
plane is rotated about the X axis of the
construction laser.
1 609 929 F28
English–7
(03.08) T