Installation - Siemens SIDOOR Gebrauchsanweisung

4

Installation

WARNING
Risk of injury and damage to property as a result of incorrect installation
Improper and incorrect installation can lead to serious injuries.
Note and follow the installation instructions for safe installation.
Installation of the geared motor
Note
Optional components
The components: rubber-metal anti-vibration mount, mounting bracket, tensioning device / mounting bracket, deflector pulley
and door clutch holder are optional and can be obtained from Siemens. Additional information can be found on the internet
(http://support.automation.siemens.com/WW/view/en/61054609/133200).
The mechanical installation of the geared motor is performed in the following steps:
1. Install the geared motor
geared motor on the mounting bracket
2. Install the deflector pulley
pulley ⑦ are aligned. They should be aligned as precisely as possible with one another (flush).
3. Feed the toothed belt
in the door clutch holder
4. Tension the toothed belt with the aid of the tensioning device
midpoint of the toothed belt can be pushed in by approximately 3 cm for every meter of distance between the drive pinion
and the deflector pulley.
5 Connection
Insert the motor connector into the corresponding controller slots:
● Slot X4201 for the motor windings and X7000 for the sensor signals (for ATE250S)
If the geared motor is connected to the control unit, it is detected automatically during the commissioning of the door control.
10
④
onto the motor mount
①
.
⑦
, if necessary with a mounting bracket
⑤
over the deflector pulley
⑥
. Screw the door clutch holder together.
① Mounting bracket
②
Motor mount
③
Drive pinion
④ Geared motor
⑤
Toothed belt
②
(rubber-metal anti-vibration mount). Then, if necessary, mount the
⑧
. Ensure that the drive pinion
⑦ ③
and the drive pinion
⑧
. The correct tension has been reached when the
⑥ Door clutch holder
⑦
Deflector pulley
⑧
Tensioning device /
mounting bracket
⑨ Door
③
, and lay both open ends of the toothed belt
Electronically commutated geared motors
A5E31837904/001, 05/2013
and deflector