Emergency Emptying Out; Frost Precautions; Troubleshooting - AEG LAVAMAT 82470 BI Benutzerinformation

20°

EMERGENCY EMPTYING OUT

If the water is not discharged, proceed as
follows to empty out the appliance:
1. pull out the plug from the power
socket;
2. close the water tap;
3. if necessary, wait until the water has
cooled down;
4. place a bowl on the floor;
5. place the end of the emergency emp-
tying hose into the bowl;
6. Remove its cap. The water should
drain by gravity into the bowl. When
the bowl is full, put the cap back on
the hose. Empty the bowl;
Repeat the procedure until water
stops flowing out;
7.
clean the pump if necessary as previ-
ously described;
8. replace the emergency emptying
hose in its seat after having plugged
it;
9. screw the pump again.

TROUBLESHOOTING

Certain problems are due to lack of sim-
ple maintenance or oversights, which can
be solved easily without calling out an en-
gineer. Before contacting your local Serv-
ice Centre, please carry out the checks lis-
ted below.
During machine operation it is possible
that the yellow pilot light of button 8
blinks, one of the following alarm codes
appears on the display and at the same
time some acoustic signals sound every
20 seconds to indicate that the machine is
not working:
45°
6. Install again the inlet hose. Make sure
that the couplings are tight to pre-
vent leakages.
7. Open the water tap.

FROST PRECAUTIONS

If the machine is installed in a place where
the temperature could drop below 0°C,
proceed as follows:
1. close the water tap;
2. unscrew the water inlet hose from the
tap;
3. place the end of the emergency emp-
tying hose and that of the inlet hose
in a bowl placed on the floor. Let wa-
ter drain out;
4. screw the water inlet hose back on;
5. put the cap on the emergency empty-
ing hose again;
6. reposition the emergency emptying
hose.
By doing this, any water remaining in the
machine is removed, avoiding ice forming
and consequently damage to the appli-
ance.
When you use the machine again, make
sure that the ambient temperature is
above 0°C.
•
: problem with the water supply
•
: problem with the water draining
•
: door open
•
: anti-flooding system has activa-
ted
Once the problem has been eliminated,
press the button 8 to restart the pro-
gramme. If after all checks, the problem
persists, contact your local Service Centre.
ENGLISH
23