Makita LC1230 Bedienungsanleitung Seite 4

Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause
voltage fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.25 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected
with a fuse or protective circuit breaker having slow
tripping characteristics.
Noise
The typical A-weighted
according to EN61029:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total
determined according to EN61029:
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
noise level determined
) : 98 dB(A)
pA
) : 108 dB(A)
WA
value (tri-axial vector
2
) : 4.5 m/s
h
2
ENF002-2
For European countries only
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
ENF100-1
Metal Cutting Saw
Model No./ Type: LC1230
are of series production and
Conforms to the following European Directives:
2006/42/EC
And are manufactured in accordance with the following
standards or standardised documents:
EN61029
The technical documentation is kept by:
Makita International Europe Ltd.
Technical Department,
Michigan Drive, Tongwell,
ENG905-1
Milton Keynes, Bucks MK15 8JD, England
000230
ENG900-1
sum)
General Power Tool Safety
Warnings
ENG901-1
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for
future reference.
METAL CUTTING SAW SAFETY
WARNINGS
1. Always use safety glasses, dust mask and ear
protector.
2. Use only Makita genuine carbide-tipped saw
blade 305 mm in diameter for metal cutting.
Never use abrasive cut-off wheel or other type
of saw blades.
3. Check the blade carefully for cracks or
damage before operation. Replace cracked or
damaged blade immediately.
4. Never secure the safety cover (safety guard).
Always be sure that the safety cover moves
4
Corporation as
30.1.2009
Tomoyasu Kato
Director
Makita Corporation
3-11-8, Sumiyoshi-cho,
Anjo, Aichi, 446-8502, JAPAN
ENH003-14
the responsible
GEA010-1
ENB076-2