Albrecht AE 69-2H Bedienungsanleitung Seite 56

Scan won't
start.
Resetting the scanner
If the scanner's display locks up or stops operating
properly, you might need to reset the scanner.
Caution: This procedure clears all the information you
have stored in the scanner. Before you reset the scanner,
try turning it off and on to see if it begins working properly.
Reset the scanner only when you are sure it is not
working properly. After a reset, only the band plan
information and the preprogrammed search bands are still
memorized in the scanner!
To reset the scanner:
• Turn of the scanner.
• While holding down 2, 9, and Hold, turn on the
scanner. It takes about 3 seconds to initialize and
CLEAr appears.
Birdies
All radios can receive "birdies" (undesired signals). If your
scanner stops during Scan mode and no sound is heard, it
might be receiving a birdie. Birdies are internally generated
signals inherent in the electronics of the receiver.
Press L/O to lock out the channel, then press Scan to resume
scanning.
If you still cannot get satisfactory results while using your
scanner or if you want additional information, please contact
the ALAN technical hotline. The address and phone number
are listed in the warranty chapter at the end of this manual.
56
You must
press Scan
to scan.
The squelch
might need to
be adjusted.
One or more
channels might
be locked out.
The antenna
might need to
be adjusted.
English
Press Scan.
Adjust the squelch threshold.
See"Turning On The
Scanner and Setting Squelch".
Make sure the channels you
want to scan are not locked
out.
Check the antenna
connection.