Fehlermeldungen - EPAK Basic Line TV 44 Handbuch

7.3

Fehlermeldungen

Display
no dish
ErrorCom
Low Batt
no Data
Err HR
Err HW
Err VR
Err VW
Err SR
Err SW
Err EEP
Err IIC
Err Trck
Err ULS
Err LLS
Err Comp
Problem
No connection to the antenna unit
Communication error with antenna
unit
Power supply too low (<11.5V)
The satellite position requested by
the receiver in AutoSat mode is
not stored in antenna unit
Read error of horizontal unit
Write error of horizontal unit
Read error of vertical unit
Write error of vertical unit
Read error of signal processing unit
write error of signal processing unit
Error during storage
Error in internal communication
Error in tracking module
Error in upper limit switch
Error in lower limit switch
Compass error
English Page 23 / 34
Remedy
- Check cable connection to antenna
unit (power and antenna cable)
- Check antenna unit's power supply
Turn unit off and after 3 seconds on
again
- Check power supply connection for
antenna unit (loose cable, etc.)
- Charge battery
- Check the DiSEqC™ adjustment of
the receiver
- Add satellite and store position
(see chapter 5.1).
- Turn the unit off and on again. In
case the error reoccurs, call for
technical assistance.
see error Err HR
see error Err HR
see error Err HR
see error Err HR
see error Err HR
see error Err HR
see error Err HR
see error Err HR
see error Err HR
see error Err HR
- Compass will automatically reset
and re-calibrate. (In case the error