Special Functions Via The Standby Mode; Fastscan Function (Us Only) - EPAK Basic Line TV 44 Handbuch

You are now back in the main menu and can switch to other satellites or make adjustments
in the Setup menu by pressing the  key.
6.3

Special functions via the Standby mode

The following information can be obtained via the Standby mode: software version of
antenna unit and control unit, serial number and operating hours counter.
Please proceed as follows:
1. Turn on the control unit. The display shows Init, meaning initialization is started. Wait
for the initialization to be completed, and then press the  key to enter the Standby
mode.
2. To obtain the special functions, press and hold the  key while switching between the
following functions with the  key:
" serial number.
" operating hours counter.
" software version of the antenna unit: VA X-XX
" software version of the control unit: VC X-XX
3. After releasing the  key, the display returns to Standby.
6.4

Fastscan function (US only)

The tracking system works faster with the Fastscan function. However, if the antenna is
locked to a satellite and the TV does not show a picture, the Fastscan function can be
deactivated by following these steps:
1. Press  repeatedly until the display shows Setup (flashing), then press . Enter
password, see chapter 3.4. If the password is correct you are in the Setup menu with
Tracking on the display.
2. Press  repeatedly until FastScan appears. Press  to confirm.
3. Press 
4. The display now returns to FastScan. Press  until quit appears and confirm
with . The display shows Setup (flashing).
You are now back in the main menu and can switch to other satellites or make adjustments
in the Setup menu by pressing the

t o switch from On to Off, and confirm with .
English Page 20 / 34
 

key.