Functional Description; Lock Button - Makita DF010D Bedienungsanleitung

Tips for maintaining maximum battery life
1. Charge the
completely discharged.
Always stop tool operation and charge the
battery cartridge when you notice less tool
power.
2. Never recharge a fully charged
cartridge.
Overcharging shortens the battery service life.
3. Charge the battery cartridge with room
temperature at 10 ﾟ C - 40 ﾟ C (50 ﾟ F - 104 ﾟ F).
Let a hot battery cartridge cool down before
charging it.
4. Charge the battery cartridge once in every six
months if you do not use it for a long period
of time.
battery cartridge

FUNCTIONAL DESCRIPTION

before
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before adjusting or
checking function on the tool.
battery
Installing or removing battery cartridge
Fig.1
Always switch off the tool before insertion or
•
removal of the battery cartridge.
To remove the battery cartridge, withdraw it from
•
the tool while pressing the buttons on both sides of
the cartridge.
To insert the battery cartridge, align the tongue on
•
the battery cartridge with the groove in the housing
and slip it into place. Always insert it all the way
until it locks in place with a little click. If not, it may
accidentally fall out of the tool, causing injury to
you or someone around you.
Do not use force when inserting the battery
•
cartridge. If the cartridge does not slide in easily, it
is not being inserted correctly.

Lock button

Fig.2
When the lock button is in the locked position B, the
switch cannot be actuated.
When the lock button is in the unlocked position A, the
switch can be actuated.
Switch action
Fig.3
CAUTION:
Before inserting the battery cartridge into the tool,
•
always check to see that the switch actuates
properly and returns to the "OFF" position when
released.
To start the tool, first move the lock button to the
unlocked position A to release the switch. And then
simply push the switch on the
clockwise rotation and the
counterclockwise rotation Release the switch to stop.
CAUTION:
Always check the direction of rotation before
•
operation.
Change the direction only after the tool comes to a
•
complete stop. Changing the direction of rotation
before the tool stops may damage the tool.
When not operating the tool, always place the lock
•
button in the locked position .
Speed change
Fig.4
To change the speed, first switch off the tool and then
slide the speed change lever to the "2" side for high
5
C side for the
D side for the