Lightning Instructions For Barbecue - Klarstein 10032308 Bedienungsanleitung

LIGHTNING INSTRUCTIONS FOR BARBECUE

1. Open the hood of the barbecue before attempting to light the burners.
2. Turn all the control knobs clockwise to "OFF" position.
3. Connect the regulator to the gas bottle. Turn the gas supply "ON" at the regulator.
Check with the use of soapy water for any gas leakage between the bottle and the
regulator.
4. Push down the front left control knob and keep pressing whilst turning anti-clockwise
to the "HIGH" position (a clicking sound is heard), this will light the left hand burner.
Observe if the burner has lit. If not repeat this process.
5. If the burner has not lit after retrying wait 5 minutes and repeat step 4.
6. Adjust the heat by turning the knob to the High/Low position.
7. If the burner does not light. Light the appliance with a match using the lighting hole
in the side of the appliance. Consult your gas dealer to rectify the ignition.
8. To light the remaining burners in sequence from left to right, and repeat 4 above.
The crosslighting channel between the burners will light the burner adjacent to it.
9. To turn the barbecue 'OFF' turn the cylinder valve or regulator switch to the 'OFF'
position and then turn the control knob on the appliance clockwise to the 'OFF'
position.
Warning: If the burner fails to ignite, turn the control knob off (clockwise) and also
turn the cylinder valve off. Wait five minutes before attempting to relight with ignition
sequence.
• Before cooking for the first time, operate the barbecue for about 15 minutes with the
lid closed and the gas turned on LOW. This will "heat clean" the internal parts and
dissipate odour from the painted finish.
• Clean your barbecue after each USE. DO NOT use abrasive or flammable
cleaners, as it will damage the parts of the product and may start a fire. Clean in
warm soapy water.
• WARNING: Danger of burns.
• Accessible parts may be very hot. Keep young children away from the hot
appliance at all times (even while cooling down!)..
• It is recommended that protective gloves (eg oven gloves) be used when handling
particularly hot components.
EN
31