Operation - Monacor ATS-16R Bedienungsanleitung

5 Selecting the Signal Source
The transmitter can be operated with a microphone,
however, a unit with line output level may also be
connected.
a) Microphone operation:
– Either use the internal microphone (5)
– or connect an external microphone, the sup-
plied electret tie clip microphone or the neck
microphone ECM-16N (available as an ac-
cessory) to the jack MIC. (6). When the jack
is connected, the internal microphone will be
switched off. Place the windshield on the mi-
crophone and attach the microphone to your
body: attach the tie clip microphone to your
clothes (e. g. lapel) via its clip or put the neck
microphone around your neck.
b) Operation with an audio unit:
Connect the output of the audio unit (e. g. cas-
sette recorder, CD player) via a 3.5 mm plug to
the jack AUX IN (10). When connecting the jack,
both the internal microphone and any external
microphone connected to the jack MIC. (6) will
be switched off.
6 Selecting the Sound Reproduction
The receiver offers different ways to reproduce the
sound.
a) Via the internal speaker:
The sound of the speaker can either be radiated
freely or be directly transmitted to your ear via
the acoustic tube earphone ET-16 available as an
accessory. Place the acoustic tube into the open-
ing (5) provided on the receiver and insert the
yellow earpiece into your ear in such a way that
a tight fit is ensured.
b) Via the supplied earphone:
Connect the earphone to the jack EAR. (6) and
attach it to your ear. When connecting the jack
EAR., the internal speaker will be switched off.
10
c) Via an amplifier system:
Connect the amplifier via a 3.5 mm plug to the
stereo jack AUX OUT (10).
Note: When connecting the jack AUX OUT, the in-
ternal speaker is still switched on. To switch it off,
connect a 3.5 mm plug to the jack EAR. (6).

7 Operation

1) With the adjusting wheel (3) on the transmitter,
select the channel for transmission from the 16
channels (0 to F): Turn the wheel in such a way
that the arrow below it will point to the desired
channel (in fig. 1, channel 0 is adjusted as an
example).
Set the adjusting wheel (3) on the receiver to
the same channel.
2) Attach the units to your clothes, e. g. your belt,
via their clips (7).
For attaching the units to your body, the follow-
ing items are available as additional accessories:
– ATS-16BAG, protective bag, to be attached to
your belt via a loop
– ATS-16CORD, neck cord
(for attaching it to the unit see fig. 3)
3) To switch on the units, turn the control (4) clock-
wise from the position OFF:
On the transmitter, the LED TX (1) shows green to
indicate transmission of a radio signal.
OPEN
➂