P4 Chk" - Enabling Filter And Enabling Totalisation In Unloading; Error Messages; Recycling Instruction - Scale House AFWC30 Benutzerhandbuch

(*) rESEt
For use of the manufacturer.
(*) SEtGrA GRAVITY ZONE AND ZONE OF USE
Through this step one selects the acceleration value of calibration and of use of the instrument:
Manual entry of the g value: one may manually enter the gravitational acceleration value; one must modify
the 6 decimal digits of the gravitational acceleration.
In case one enters a wrong g value: the minimum decimal value is suggested (9,75001); a wrong value is any
decimal number that is not between 9,75001 and 9,84999 (inclusive).
(!) g = 9,80655
(*) With approved instrument the parameter is read-only.
7.9.4 "P4 CHK" – ENABLING FILTER AND ENABLING TOTALISATION IN UNLOADING
By pressing ZERO one chooses whether to enable the filter intervention for the stability of the weight indication
or enable the totalisation in unloading function, useful for totalising with a negative net weight.
Press TARE to change the options:
ModE 1
ModE 2
ModE 3
ModE 4
Confirm with ZERO, or press PRINT/M+ to exit without confirming.

8. ERROR MESSAGES

ERROR MESSAGES
- - oL - -
Err 1
Err 2
Err 4
Err 6

RECYCLING INSTRUCTION

The crossed-out wheeled bin on the product means that at the product end of life, it must be taken to
separate collection or to the reseller when a new equivalent type of equipment is purchased. The
adequate differentiated refuse collection in having the product recycled, helps to avoid possible
negative effects on the environment and health and supports the recycling of the materials of which
the equipment is made. The unlawful disposal of the product by the user will entail fines foreseen by
the current regulations.
Filer disabled and totalisation in unloading disabled.
Filter enabled and totalisation in unloading disabled.
Filter disabled and totalisation in unloading enabled.
Not used in this application.
DESCRIPTION
Over range
Data error
Time error
Zero Setting Error
Input signal greater
than 3mV/V
RESOLUTION
Remove weight from the scale.
Correctly enter the date in the "yy:mm:dd" format
Correctly enter the time in the "hh:mm:ss" format
Upon start-up or when the ZERO key is pressed, the weight on the
scale exceeds the percentage programmed on the max. capacity.
Remove the excess weight and retry.
Indicates that the A/D converter value is greater than the maximum
value:
- Remove the weight from the scale if it's exceeding.
- The load cell or the electronics could be damaged.
16