Set-Up Environment Block Diagram; F0 H-L" - Setting Weight Thresholds - Scale House AFWC30 Benutzerhandbuch

7.1 SET-UP ENVIRONMENT BLOCK DIAGRAM

SETUP
ENVIRONMENT
7.2 "F0 H-L" – SETTING WEIGHT THRESHOLDS
Set Lo SETTING LOWER THRESHOLD
By pressing ZERO the display shows "000.000kg", with the first digit blinking, and it's therefore possible to set the
lower threshold:
- Use the F key to clear the value, the TARE key to increase the value of the digit, the U key to go on the previous
digit and the SMPL key to go on the following digit.
- Confirm with ZERO the entered value or press PRINT/M+ to exit without confirming.
Set Hi SETTING UPPER THRESHOLD
By pressing ZERO the display shows "000.000kg", with the first digit blinking, and it's therefore possible to configure
the upper threshold:
- Use the F key to clear the value, the TARE key to increase the value of the digit, the U key to go on the previous
digit and the SMPL key to go on the following digit.
- Confirm with ZERO the entered value or press PRINT/M+ to exit without confirming.
F0 H-L SET Lo
SET Hi
F1 toL to CLr
to P-C
to Prt
F2 Unt g
lb
OZ
lbOZ
F3 ti SEt dA
SEt ti
F4 oFF CLoCK
bL
bEEP
P Cont,
F5 Prt SEi rE, ASK,
P AUto, P Prt
F6 rSt
ProG Pin
XXX.XXX
XXX.XXX
on, oFF
on, oFF
on, oFF
on, oFF
on, oFF
on, oFF
CLK on, CLK oFF
EL AU, EL oFF,
bP 1, bP 2, bP 3
P1 rEF Azn 0
0AUto
0rAnG
SPEEd
P2 CAL dECi
inC
CAP
CAL
P3 Pro tr i
Count
P4 CHK ModE 1, ModE 2, ModE 3, ModE 4
12
oFF, 0.5d, 1d, 2d, 4d
0, 2, 5, 10, 20
0, 2, 4, 10, 20, 50, 100
0, 1, 2, 3, 4
1, 2, 5, 10, 20, 50
XX.XXX
XXX.XXX
XXXXXX