Troubleshooting - auna Stealth Bar 70 Hinweise

USB
You can use the USB slot to recharge any mobile devices such as mobile
phones or tablets. The connection power is 5V at 500mA.
When connecting any external players, please make sure to turn its output
volume up to some extent. The energy saving feature of the Stealth Bar 70 is
set to switch the device to standby after 19 minutes of no (or too low) audio
input.

TROUBLESHOOTING

The remote Use the remote control near to the unit.
control does not
Point the remote control at the remote control
work
sensor on the unit.
Replace the batteries in the remote control with new
ones.
Remove any obstacles between the remote control
and the unit.
Loud hum or Maybe the plugs and sockets are dirty. Wipe them
noise with a cloth slightly moistened with an appropriate
non-abrasive cleaning solution.
The unit does not The unit may freeze up during use. Switch off and
respond when then switch on the unit again at the mains socket to
pressing any reset it.
buttons
No sound Make sure that the unit is not muted. Press MUTE or
VOL + to resume normal listening.
Ensure that the audio setting of the input source (e.g.
TV, game console, DVD player, etc.) is set to PCM
mode while using Optical connection.
EN
25