Troubleshooting; Specifications - auna 10011686 Bedienungsanleitung

Note:
You should now be able to place the speakers freely from room to room without disruption. If
disruption should occur (signal breaks up), press the speaker's "SCAN" auto-tuning button to
maximize best reception.
If you hear interference from other components, switch the channel control of transmitter, and then
move the speakers to other free location. You can re-adjust the tuning control by moving it either
channel 1 or, 2 of the transmitter, then pressing "SCAN" auto-tuning button for best reception.
When transmitting / receiving over long distances, the signal from the system will become weaker.
Switching off
1. Turn the VOLUME ON/OFF knob until the click sound is heard to turn off the speaker and the LED
light goes off
2. For protection of the transmitter and power saving, the transmitter will cut off automatically if
there is no/weak operation input signal from audio source for 4 minutes.
In other words, if the signal comes back, the transmitter will work again automatically.
NO SOUND
- Ensure the AC adaptor is fully inserted into the AC outlet and the power connection input on the
transmitter.
- Ensure the speaker is switch ON.
- Speaker's battery capacity is too low, replace with new batteries or connect the AC adaptors to
the speakers.
- Ensure the TV or audio component is ON.
- The connected audio / video equipment is not playing. Start playing the equipment.
- The volume of speaker is too low, adjust the volume to an appropriate level.
DISTORTED
- Press the "SCAN" button on the speakers until matching the frequency of the transmitter.
- Change the position of the channel selector on the transmitter. You must then press the SCAN
button on the speaker.
- Battery capacity is too low. Replace with the new battery.
- Ensure the volume level of speakers is adjusted properly.
- The speaker is too far from transmitter, move closer.
- The input level of the audio signal is too low. Turn up the volume of the audio source equipment.
Transmission Mode:
Carrier Frequency:
Operation Voltage:
Frequency Response:
Distortion :
S/N Ratio :
Channel Separation:
Operation Distance:
Trouble Shooting

Specifications

UHF stereo
863 MHz
Transmitter, DC 12V 200mA
Speaker, 6 X 'AA' size Alkaline batteries or DC 12V 600mA adaptor
20Mz - 13KHz
1.5%
50dB
30dB
Up to 100M (Open Area)
14