Safety Tips - Char-Broil 468101715 Betriebsanweisungen

Safety Tips

Before opening gas cylinder valve, check the regulator for
Ÿ
tightness.
When appliance is not in use, turn off all control knobs and
Ÿ
gas.
Use long-handled barbecue utensils and oven mitts to
Ÿ
avoid burns and splatters. Use protective gloves when
handling hot components.
Be very careful when you open the lid, since hot steam may
Ÿ
escape.
Be very careful when children, the elderly, or pets are
Ÿ
nearby.
If you notice grease or other hot material dripping from
Ÿ
appliance onto valve, hose or regulator, turn off gas supply
at once. Determine the cause, correct it, then clean and
inspect valve, hose, and regulator before continuing.
Perform a leak test.
Do not store objects or materials inside the appliance cart
Ÿ
enclosure that would block the flow of combustion air to the
underside of either the control panel or the firebox bowl.
DO NOT disconnect or change gas container within 3m of
Ÿ
an open flame or other ignition source.
Cylinder Placement
Cylinder cannot be placed under or in the appliance. Cylinders
are to be placed to the side and rear of the applaince.
Cylinders are to be a maximum diameter of 310mm and
maximum height of 600mm.
Regulator Requirements
A regulator must be used with this appliance. Use only gas
supplied then use only regulator certified according to
EN12864 / EN16129 (Flow rate max. 1.5 kg/h) and approved
for your country and gas specified in Technical Data.
Hose Requirements
Use only approved hose which is certified to appropriate EN
standard and does not exceed 1.5m length. For Finland, the
hose length shall not exceed 1.2m.
Before each use, check to see if hoses are cut or worn. Make
sure hose is not kinked. Make sure that when connected hose
does not touch any warm surfaces. Replace damaged hoses
before using appliance. Replace hose as required by national
requirements.
Ignitor Lighting
Do not lean over appliance while lighting.
1. Turn gas burner control valves to
2. Turn ON gas at cylinder.
3. Open lid during lighting.
4. To ignite, push and turn burner to
5. Push and hold ELECTRONIC IGNITION button.
6. If ignition does NOT occurs in 5 seconds, turn the burner
controls to , wait 5 minutes and repeat lighting procedure.
7. To ignite remaining burners, repeat steps 4 and 5. If ignitor
does not work, follow match lighting instructions.
WARNING
Turn controls and gas cylinder off when not in use.
Match-Lighting
• Do not lean over appliance while lighting.
1. Open lid. Turn on gas at cylinder.
2. Place match into match holder, ( hanging inside of cart)
light match, place into lighting hole and place next to
burner ports.
3. Push in and turn burner knob to
being lit. Be sure burner lights and stays lit.
4. Light other burner by repeating steps 2 and 3.
Environmental protection
Discarded electric appliances are recyclable
and should not be discarded in the domestic
waste! Please actively support us in
conserving resources and protecting the
environment by returning this appliance to the
collection centres (if available).
3
.
.
for burner