Viper CEX410 Benutzerhandbuch Seite 12

are marked on the serial label.
This information is useful. Use the following
table to write down the machine
identification data when requiring spare
parts for the machine.
Machine model ......................................
Machine serial number ..........................
Machine components (refer to page 2)
1. spray mode switch 2. power cable hook 3.
power cord 4. handle tube (stainless) 5.
solution tank 6. rear wheel 7. machine base 8.
"Kickstand" pedal 9. base height adjusting
knob 10. vacuum shoe knob 11. vacuum hose
input 12. dome 13. filling port 14 .viper logo
15. vacuum shoe 16. control panel 17. hand
tool (optional) 18. hand tool spray nozzle 19.
hand tool quick connector 20. hand tool
valve handle 21. hand tool vacuum hose 22.
cable clamp 23. base panel 24. handle
adjusting knob 25. hose clamp 26. sight tube
coupling 27. sight tube 28. vacuum hose 29.
recovery tank drain hose 30. accessory quick
coupler 31. solution filter 32. shaft 33.
"Kickstand" machine holder 34. nozzle base
35. spray nozzle 36. wear plate 37. "Kickstand"
nut 38. machine assemble bolt 39. rolling
brush 40. rolling brush holder 41. recovery
tank dome catch 42. recovery tank 43. float
filter cover 44. float cover 45. foam filter 46.
float filter holder 47. V-belt cover
Vacuum shoe and rolling brush installation
Vacuum shoe installation (refer to F2):
1) First, placed the machine upright on the
floor.
2) Lift the vacuum shoe knob.
3) Insert the vacuum shoe to suction hose
and mounting base in correct position.
4) Release the vacuum shoe knob.
5) pull back the vacuum shoe, if it doesn't
move, the installation is complete.
Rolling brush installation (refer to F3):
1) Place the machine to side position.
2) Install one side of the rolling brush with
the locating slot to bearing mounting rack
and press in the other side to rolling brush
holder. Tip: First , squeeze one side of brush
and ensure the end with a groove has been
installed in place and then install the other
side.
3) If the rolling brush rotates smoothly, the
installation is complete.
Handle direction and Vacuum shoe / rolling
brush height adjustment Handle direction
adjustment (refer to F4)
1) The appliance can adjust the height of the
handle according to use's stature or personal
operation habit.
2) Holding the handle adjusting knob and
rotate in the opposite direction to loosen the
handle.
3) Adjust the handle to the appropriate
position and tighten the knob.
Vacuum shoe/rolling brush adjustment
When the machine working in different piles
of carpet or the rolling brush has a certain
amount of wear and tear, the operators can
increase the cleaning performance of the
machine by adjusting the height of the
vacuum shoe and rolling brush (refer to F5)..
1) Machine running speed label (0
indicates the machine speed from slow to
fast).
2) Rolling brush pressure label (-
Indicates the pressure on the brush is
increasing).
3) Vacuum shoe adjustment knob.
Holding the vacuum shoe adjustment knob
and rotate it in the same direction, move the
vacuum shoe up or down to the appropriate
position.
Control panel (refer to F6).
1. Power switch 2. Water pump switch
3. Vacuum motor switch 4. Fuse for roller
brush motor 5. Fuse for vacuum motor
Machine operation
Prior to operation
1) Inspect power cable and extension cable
for damage. Replace cable if damage is
found.
2) Vacuum the area to be cleaned to remove
most of the solid debris before using the
machine to clean.
11
ENGLISH
➝
MAX
➝
+