Troubleshooting - Televes OMNINOVATF2 Bedienungsanleitung

Troubleshooting

WHAT IS HAPPENING POSSIBLE WHY
Short circuit at the
1 The PSU LED is OFF.
output of the PSU.
You are in an area
in which the level
of the TV signal is
very strong.
The image is not stable,
2
freezes or pixelate. The level of the
signal at the
output of the
antenna is very
weak.
TV receiveer is
not powered
adequately.
No picture and no
No signal reaches
3
sound.
the receiver.
Improper
operation of TV
receiver.
Malfunction, without a
4 cause that matches the
above.
WHAT TO DO
Disconnect the coaxial cable
that runs to the PSU.
Disable the device BOSS-Tech
by disconnecting the PSU from
the mains.
Check for any obstacle in front
of the antenna.
Verify that the PSU LED is green.
Check that the receiver is
plugged to the mains.
If the fault is not due to point
1, check that the coaxial cable
connecting the receiver and TV
is not short circuit.
Check the channel tuning on
the receiver and program them
correctly.
- -
WHAT TO CHECK/SOLUTIONS
If now the LED turns ON, it means that there is a short circuit in coaxial cable. Check for any
strand of the braid making short circuit with the inner conductor of the cable on either
connector of end of the cable.
If the LED does not turn ON, the problem may be in the PSU, whether the network adapter
or the power injector (in this case it is assumed that the battery is in good condition). In
either case, replace the damaged item by a new one.
Verify that the image is good and stable.
Remove the obstacle or place the antenna somewhere else.
If the LED is not green, check the mains power connection.
Check the plug on the receiver and check the power cord is not in open circuit or broken.
If there is a short in the cable, replaceit by a new one.
Return a sweep of all the TV channels that are in the area for tune them again.
Consult your dealer or contact a technical specialist.
17
EN