Operating Mode; Troubleshooting - Televes DINOVA BOSS Bedienungsanleitung

Operating mode

Once the antenna is installed, the operating mode
is chosen. The antenna has two operating modes:
passive and active, if power is supplied.
PASSIVE MODE: Without power, the antenna
works like a passive antenna, capturing UHF signals
(and VHF in the MIX version). Operating mode
suitable for locations near repeaters where the
signal level is good.
ACTIVE or intelligent MODE: When providing
power supply (range between 12 and 24V
antenna amplifies the received signals in both UHF
and VHF bands (MIX version). This operating mode
is recommended for locations where the received
signal level is poor.

Troubleshooting

FAILURE
- LEDs are OFF.
- There is neither picture
nor sound.
), the
- Poor picture.
- Other.
CHECK ACTION
- Is there mains voltage?. - Check electrical installation.
- Is the battery connection OK?. - Check the battery polarity. If connections are OK, then
- Possible short circuit. check the battery condition.
- Check the connections.
- Channel not tuned in the TV - Tune the TV set to the local TV channels.
set correctly?. - Check installation cable and connectors: there might
be a shortcircuit. (Check that there is DC voltage at
the PSU's antenna connector).
- Obstacles in front of the - Remove the obstacles or change the antenna
antenna?. location.
- Consult with you local distributor.
13
EN