Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting - Televes OMNI-NOVA BOSS Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für OMNI-NOVA BOSS:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 27

Troubleshooting

WHAT IS HAPPENING
POSSIBLE WHY
1
The control module LED
Short circuit at
is OFF .
the output of the
antenna control
module. rol de
antena.
2
The image is not stable,
You are in an area
freezes or pixelate.
in which the level
of the TV signal is
very strong.
The level of the
signal at the
output of the
antenna is very
weak.
3
No picture and no sound
TV receiveer is
not powered
adequately.
No le llega señal al
receptor
Improper
operation of TV
receiver
4
Malfunction, without a
cause that matches the
above
WHAT TO DO
Disconnect the coaxial cable
that runs to the antenna control
module.
Disable the device BOSS-Tech
by pressing the switch on the
antenna control module. The
LED should turn red.
Check for any obstacle in front
of the antenna.
Verify that the control module
LED is green.
Check to see if the IEC coaxial
connectors are firmly plugged
into the receptacle.
Check that the receiver is
plugged to the mains.
If the fault is not due to point
1, check that the coaxial cable
connecting the receiver and TV
is not short circuit.
Check the channel tuning on
the receiver and program them
correctly.
-
-
WHAT TO CHECK/SOLUTIONS
If now the LED turns ON, it means that there is a short circuit in coaxial cable. Check for any
strand of the braid making short circuit with the inner conductor of the cable on either
connector of end of the cable
If the LED does not turn ON, the problem may be in the power control module, whether the
network adapter or the cigarette lighter adapter (in this case it is assumed that the battery is
in good condition). In either case, replace the damaged item by a new one.
Verify that the image is good and stable.
Remove the obstacle or place the antenna somewhere else.
If the LED is not green, press the switch to put it in red (fig. 10).
Make sure that the IEC connector of the coaxial cable is firmly connected.
Check the plug on the receiver and check the power cord is not in open circuit or broken.
If there is a short in the cable, replaceit by a new one.
Return a sweep of all the TV channels that are in the area for tune them again.
Consult your dealer or contact a technical specialist.
23
EN

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis