Programming The Remote Control - Grundig Atlanta SE 7250 PIP/DOLBY Service Anleitung

Allgemeiner Teil / General Section
1
4
7
26
1 - 26

PROGRAMMING THE REMOTE CONTROL

Programming function levels
1
Move the slide-switch to the function level (SAT, VCR, DVD) you want to
programme.
– The display of the selected function level lights up for about three seconds.
2
Simultaneously press »AUX« and »3« until the display of the selected func-
tion level lights continuously.
3 Point both remote controls at each other at a distance of about five centi-
meters.
2 3
4
Press the button on the TP 850 C which is supposed to be programmed.
TV
The display of the selected function level flashes once.
5 6 SAT
VCR
DVD
8 9
5 Press the function button which is supposed to be learned on the original
remote control until the display of the selected function level on the TP 850
0
flashes twice.
Note:
If the function could not be learned, all four displays on the TP 850 will flash
twice. In this case, repeat steps
6 To finish the settings, simultaneously press »AUX« and »3«.
The display flashes twice.
PROGRAMMING THE REMOTE CONTROL
Reset
You can reset the remote control back to the settings it was given in the factory.
Resetting a function level
1 Move the slide-switch to the function level (SAT, VCR, DVD) which is sup-
posed to be reset.
2
Simultaneously press »PIP« and »6« until the display of the selected function
level flashes twice.
Resetting all function levels (except TV)
1
Move the slide-switch to the TV function level.
2
Simultaneously press »PIP« and »6« until the displays of the function levels
»SAT«, »VCR«, »DVD« flash twice.
___________________________
3 to 5 .
___________________________
CUC 1832 / 1930 / 1931
27
GRUNDIG Service