Grundig Atlanta SE 7250 PIP/DOLBY Service Anleitung Seite 23

CUC 1832 / 1930 / 1931
18
20
GRUNDIG Service
CONNECTION AND PREPARATION
Connecting a PC (VGA)
You can use the TV set as a PC monitor.
The television set can set itself to the following input signals:
640 x 480 Pixel, 60 Hz/31.5 kHz
640 x 400 Pixel, 70 Hz/31.5 kHz
640 x 350 Pixel, 70 Hz/31.5 kHz
AV3
CENTRE
EXTERN
SUBW
L
AUDIO IN
AUDIO
R
L
SURR
R
AV2 AV1
1 Connect the VGA source (e.g. computer, games console) to the »VGA«
socket using a commercially available VGA cable.
2
Connect the computer's audio output (if available) to the »AUDIO« sockets
using a commercially available Cinch cable.
Note:
One of the above-mentioned resolutions must be set on the PC (see the PC's
system control).
The display of a connected laptop computer must be switched off (using the
keyboard or the laptop's system control; see the operating manual of the
laptop).
When using a laptop, it has to be first connected and then switched on.
SETTINGS
______________________________________________________________________________
Switching the TV set on/off
An LED next to the mains switch indicates the current operating mode by a
corresponding colour.
Green = Operation.
Yellow = Standby (EPG mode, copy mode).
Red = Standby (energy saving mode, timer programmed).
Switching the TV set on
1
Press »IO« on the TV set.
The TV picture appears on the screen.
Switching the TV set to standby
1
Press » « on the remote control once.
Switching the TV set off definitely
1 Press »IO« on the TV set, or
press » « on the remote control twice.
Condition:
The ecologic switch must be activated (Dialog Centre, »Special Functions«
menu).
Note:
The ecologic switch is not activated if a timer is programmed or the copy
mode activated.
Switching on again is only possible with »IO« on the TV set.
_______________________________________
INT
CENTRE
EXT
INT
SUBW
EXT
L
R
Allgemeiner Teil / General Section
1 - 23