Herunterladen Inhalt Inhalt Diese Seite drucken

Maintenance And Care; Changing The Spool (15); Replacing The Blade; Storage - AL-KO MT 36 Li Betriebsanleitung

Vorschau ausblenden Andere Handbücher für MT 36 Li:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1

Maintenance and care

Procedure if the blade jams
Thick vegetation, young trees or growth can
block the blade and bring it to a stop.
Avoid blocking by observing the direction in
which the growth inclines and cut from the
opposite side.
If the blade becomes entangled when cutting:
Immediately stop the motor.
Hold the appliance at a height so the
blade does not jump or break.
7 MAINTENANCE AND CARE
WARNING!
Danger of cutting injuries
Danger of cutting injuries when reaching
into sharp-edged, moving appliance parts
and into cutting tools.
Before maintenance, care and clean-
ing work, always switch off the appli-
ance. Remove the rechargeable bat-
tery.
Always wear protective gloves during
maintenance, care and cleaning
work.
7.1

Changing the spool (15)

Replacement spool: Art. no. 113478, set of 2.
Precondition: The appliance must be switched off
and the rechargeable battery must be removed
from the basic appliance.
Inserting and pulling out the spool
1. Press (15/a) the two unlocking buttons (15/1)
at the same time and remove (15/b) the
cover (15/2).
2. Pull out (15/c) the empty spool (15/3).
3. Insert the new spool (15/3).
4. Thread the cutting line (15/4) through the
openings (15/5) of the cover towards the out-
side.
5. Put on the cover (15/2) and press on until it
engages.
6. Insert the rechargeable battery in the basic
appliance.
Bring the cutting line to the required length
1. Switch on the appliance for approx. 10 s,
then switch it off again. The cutting line
lengthens.
2. Wait until the cutter head has come to a stop.
442105_a
3. Repeat the previous two steps approx. 3 to 5
times until the cutting line has the required
length.
7.2

Replacing the blade

Replacement blade: Art. no. 113479
Replacing the blade: see chapter 4.5 "Fitting/re-
moving the blade (09, 10)", page 24.

8 STORAGE

Thoroughly clean the appliance after each use
and – if present – attach all covers. Store the ap-
pliance in a dry, lockable place out of the reach of
children.
Carry out the following jobs before intervals in
work lasting for longer than 30 days:
Clean the blade and spray with rust-proofing
oil.
Thoroughly clean the appliance and store it in
a dry place.

9 HELP IN CASE OF MALFUNCTION

CAUTION!
Risk of injury
Sharp-edged and moving appliance parts
can lead to injury.
Always wear protective gloves during
maintenance, care and cleaning
work.
Malfunc-
Cause
tion
Grass is no
Blade is
longer
blunt.
cleanly cut.
Re-
Grass is too
chargeable
long or too
battery op-
wet.
erating time
is signific-
antly
Cutting
shorter.
height is too
low.
Remedy
Have the blade
sharpened. Con-
tact an AL-KO
service centre.
Replace the
blade.
Cut the grass
at a greater
height.
Let the grass
dry.
Cut the grass at a
greater height.
25

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Bca 36 li

Inhaltsverzeichnis