Appliance Safety; Electrical Safety; Safety Instructions For Brushcutting Attachment; Work Instructions - AL-KO MT 36 Li Betriebsanleitung

GB
■
Keep hands, feet and other parts of the body
away from moving appliance parts (e.g. saw
chain, blade system).
■
Appliance parts, such as engine covers and
cutting tools, can heat up considerably during
operation. Do not touch them. After switching
off, wait until the appliance has cooled.
3.5

Appliance safety

■
Only use the appliance under the following
conditions:
■
The appliance is not soiled.
■
The appliance show no signs of damage.
■
All controls function properly.
■
Keep all appliance handles dry and clean.
■
Do not overload the appliance. It is intended
for light work in the private sector. Overload
can lead to damage to the appliance.
■
Never operate the appliance with worn or de-
fective parts. Always replace defective parts
with original spare parts from the manufac-
turer. If the appliance is operated with worn
or defective parts, guarantee claims against
the manufacturer are excluded.
3.6

Electrical safety

■
To avoid short-circuits and destroying elec-
trical components:
■
Protect the appliance against humidity
and do not use it in the rain.
■
Do not spray the appliance with water.
■
Do not open the appliance.
NOTE
Heed the safety instructions for the re-
chargeable battery and for the charging
unit in the separate operating instruc-
tions.
3.7 Safety instructions for brushcutting
attachment
3.7.1

Work instructions

■
Always operate the machine with two hands.
■
Always keep hand and feet away from the
cutting device, above all when switching on
the motor.
■
Wait for the cutting device to come to a
standstill after the motor has been switched
off.
■
Only remove cuttings when the motor and
cutting device are at a standstill.
22
■
Because of danger of cutting injuries, do not
touch the line cutter with unprotected hands.
■
After pulling out a new line, always bring the
appliance into its normal working position be-
fore switching it on.
■
Do not use a metallic cutting line.
■
Always keep the guard plate, spool head and
motor clear of mowing residues.
■
People who are not familiar with the appli-
ance should practice handling it while the
motor is turned off.
■
When working on a slope:
■
Never work on a smooth and slippery
slope.
■
Always mow across the slope, never
down or up.
■
Always stand below the cutting device.
■
After contact with a foreign object:
■
Switch off the motor.
■
Check the machine for damage.
■
Attach the blade so that it does not loosen
and fall during operation.
3.7.2

Vibration load

WARNING!
Danger due to vibration
The actual existing vibration emission
value when using the device may differ
from the value specified in the operating
instructions or the value specified by the
manufacturer. This can be caused by the
following factors that must be observed
before every use or during use:
■
Is the device being used as inten-
ded?
■
Is the material being cut or pro-
cessed in the proper manner?
■
Is the device in a proper condition of
use?
■
Is the cutting tool properly sharpened
or is the correct cutting tool installed?
■
Are the handle grips and any optional
vibration grips mounted, and are they
firmly attached to the device?
Countermeasures
■
If you notice an unpleasant sensation or dis-
colouration of the skin on your hands when
using the device, stop work immediately.
Safety instructions
BCA 36 Li