Product Identification; Monitor Panel; Installation Location; Electrical Requirements - Technibel SCDV106C5VA Bedienungsanweisungen

PRODUCT IDENTIFICATION

01 Infrared rays remote control unit
02 Air filter handle
03 Air outlet

04 Monitor panel

05 Quick coupling cover
06 Outdoor unit
07 Outdoor unit basket or support
08 Flexible tube
09 Air intake
10 Electric cable with plug
MONITOR PANEL
4
2 3
1
6 5
1. TIMER lamp: This lamp lights up when the system is being
controlled by the timer or sleep mode.
2. OPERATION lamp: This lamp lights up during operation.
It blinks once to announce that the remote control signal has
been received and stored. It blinks continuously during the
protection modes (defrosting, etc.).
3. STANDBY lamp: This lamp lights up when the air conditioner
is connected to the power and ready to receive the remote
control command.
4. Receiver : receives signals transmitted from the remote control.
5. Operation button (without remote control): Push the button
to walk through the OFF, COOL and HEAT operation modes.
WARNING
The OFF position does not disconnect the power. Use the
main power switch to turn off power completely.
CAUTION
6. Water-level alarm: this lamp flashes and the air conditioner
simultaneously stops during exceeding condensate drainage
or because of malfunctioning of the condensate drainage
system.
7
COOL / DRY / FAN
3
2
1
10
1 2 3
4
6 5

INSTALLATION LOCATION

We recommend this air conditioner to be installed properly
by qualified installation technicians in accordance with the
installation instructions provided with the unit.
WARNING
Do not install this air conditioner where there are fumes
or flammable gases, or in an extremely humid space
such as a green house.
Do not install the air conditioner where excessively high
heat-generating objects are placed.
Do not install the air conditioner where the atmosphere
is extremely damp or humid (e.g. greenhouse or laundry)
it could be wetted by drops of water (i.e. in laundries).
Avoid:
To protect the air conditioner from heavy corrosion, avoid installing
the outdoor unit where salty sea water can splash directly onto
it or in sulphurous air near a spa.

ELECTRICAL REQUIREMENTS

Before using the appliance
Check that the power supply at the location where the air
conditioner is going to be used is 220/240 volt, single phase.
The air conditioner cable is M model. In case of replacement,
please contact the After Sales Service.
Before connecting the air conditioner to a power socket,
make sure that the socket is provided with an earth
connection.
Verify that the available power supply is sufficient for running
other electrical domestic appliances in use simultaneously from
the same supply. See the data plate on the unit showing the max.
absorbed powers.
3
4 5
9
COOL / DRY / HEAT / FAN
6
EG
8