Herunterladen Inhalt Inhalt Diese Seite drucken

Audiotec Fischer Match UP 7BMW Bedienungsanleitung Seite 23

7-kanal plug & play upgrade-verstärker mit integriertem 8-kanal 64 bit dsp für bmw hifi-soundsysteme
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

switch (page 17, item 1) allows to deactivate
the automatic turn-on feature of the highlevel
inputs of the System Connector 1. The feature
should be deactivated if the UP 7BMW replac-
es the amplifier of the BMW HiFi sound system
(676) or if there are e.g. disturbing noises while
switching on / off the amplifier.
Note: If the automatic turn-on function is de-
activated it is mandatory to use the remote
input terminal to power up the amplifier! The
highlevel signal of the System Connector 1 will
be ignored in this case.
To deactivate the automatic turn-on feature you
have to change the position of the Auto Remote
switch to "Off" (ex works).
8. Configuration of the internal DSP
The general amplifier settings should be
conducted with the DSP PC-Tool software
before using the amplifier for the first time.
Ignoring this advice may result in damaging the
connected speakers / amplifiers. Especially if
the UP 7BMW will be used to drive fully active
speaker systems, a wrong setup can destroy
your tweeters right away.
Information on connecting the UP 7BMW to
a computer and on how to install car-specific
sound setups can be found on page 24.
9. Connecting the remote output
This output (Remote Out) is used to supply re-
mote signals to additional amplifiers that are
connected to the Line Out of the UP 7BMW.
Always use this remote output signal to turn on
the amplifiers in order to avoid on / off switching
noises.
10. Mounting the car interior lining
After the UP 7BMW has been properly installed
and all adjustments have been made to the am-
plifier, the car interior lining can be reattached.
Caution:
The UP 7BMW amplifier has a higher power
output than the original head unit / original am-
plifier. In most cases the original loudspeakers
will be able to handle the extra power in com-
bination with the correct DSP adjustments. In
the case you make your own adjustments to the
DSP it might be possible that the original speak-
ers get overloaded and / or damaged. Therefore
we always recommend to ensure that there are
no sound distortions especially at high volumes
to avoid any damage to the speakers.
Note: Audiotec Fischer is not responsible for
any damages to OE speakers that are used in
combination with the UP 7BMW!
23

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis