Audiotec Fischer Match UP 7BMW Bedienungsanleitung Seite 16

Connectors and control units
Auto Remote
1
This switch allows to activate / deactivate the
automatic turn-on feature of the amplifier .
System Connector 2
2
Connector for the UP 7BMW cable harness.
Only use the original included connection
cable to connect the amplifier to the factory
cable harness.
Clipping LED
3
This LED lights up red if one of the analog
inputs is overdriven.
System Connector 1
4
Connector for the UP 7BMW cable harness.
Only use the original included connection
cable to connect the amplifier to the factory
cable harness.
USB Input
9
Connects the UP 7BMW to your PC.
Control pushbutton
10
Use this button to either switch between the
setups or initiate a reset of the device.
Status LED
11
This LED indicates the operating mode of
the amplifier and the setup that has been
chosen.
Control Input
12
Multifunction interface for e.g. an optional
remote control or other MATCH UP 7BMW
accessory.
16
1 2 3
9 10 11 12
4 5 6
Fuse LED
5
This LED will light up if the fuses inside the
amplifier are blown.
+12 V
6
Optional connector for the +12 V power ca-
ble to the positive terminal of the battery.
GND
7
Optional connector for the ground cable
(negative terminal of the battery or metal
body of the vehicle).
REM
8
Optional connector for the remote cable.
13 14 15
Optical Input
13
Optical input for digital stereo signals (SPDIF
format).
Gain
14
Control for adjusting the input sensitivity.
Remote Out
15
The remote output has to be used to turn on /
off external amplifiers that are connected to
the Line Out.
Line Out
16
Mono line output for connecting external am-
plifiers. Make sure that the remote output is
used to turn on these devices.
7 8
16