General Instructions - Audiotec Fischer Match UP 7BMW Bedienungsanleitung

Congratulations!
Dear Customer,
Congratulations on your purchase of this innovative
and high-qual ity MATCH product.
Thanks to more than 30 years of experience in
research and development of audio products this
amplifier sets new standards in the evolving plug
& play market.

General instructions

General installation instructions for MATCH
components
To prevent damage to the unit and possible injury,
read this manual carefully and follow all installation
instructions. This product has been checked for
proper function prior to shipping and is guaranteed
against manufacturing defects.
Before starting your installation, disconnect the
battery's negative terminal to prevent damage
to the unit, fire and/or risk of injury.
Install your UP 7BMW amplifier only at the original
mounting place of the original amplifier by using the
included mounting plate.
For a proper performance and to ensure full war-
ranty coverage, we strongly recommend to get this
product installed by an authorized MATCH dealer.
We wish you many hours of enjoyment with your
new MATCH UP 7BMW.
Yours,
AUDIOTEC FISCHER
General instruction for connecting the UP 7BMW
amplifier
The UP 7BMW amplifier may only be installed in
motor vehicles which have a 12 Volts negative ter-
minal connected to the chassis ground. Any other
system could cause damage to the amplifier and
the electrical system of the vehicle.
The positive cable from the battery for the entire
sound system should be provided with a main fuse
at a distance of max. 30 cm from the battery. The
value of the fuse is calculated from the maximum
total current draw of the car audio system.
Use only the included MATCH cable for con-
nection of the UP 7BMW. The use of other
cables can result in damage of the ampli-
fier, the head unit / car radio or the connected
loudspeakers! The fuses of the amplifier may
only be replaced by identically rated fuses
(2 x 25 A) to avoid damage of the amplifier.
Prior to installation, plan the wire routing to avoid
any possible damage to the wire harness. All
cabling should be protected against possible
crushing or pinching hazards. Also avoid routing
cables close to potential noise sources such as
electric motors, high power accessories and other
vehicle harnesses.
15