Audiotec Fischer Match UP 7BMW Bedienungsanleitung Seite 21

The MATCH UP 7BMW must be installed and
connected as follows:
Caution: Carrying out the following steps will re-
quire special tools and technical knowledge. In
order to avoid connection mistakes and / or dam-
age, ask your dealer for assistance if you have any
questions and follow all instructions in this manual
(see page 15).
1. Removal of the original amplifier
1. Carefully remove the car interior lining that
covers the original amplifier. In most cases it
is the left side panel in the trunk.
Note: The car interior lining is fastened with
several hidden screws to the metal sheet of
the car. Make sure that you have loosened
all screws before you try to remove it.
Additionally it is often fixed by numerous
plastic clips. When removing the car interior
lining the ambient temperature should not be
below 10°C.
2. First disconnect all cables from the device.
3. Loosen the bolting between the mounting
plate of the amplifier and the original mount-
ing fixture of the vehicle body (Depending on
the model, it may be necessary to dismatle
the original mounting fixture beforehand).
Then, pull out the original amplifier sideways
or upwards, depending on the type of instal-
lation.
2. Installation of the UP 7BMW amplifier
1. Fix the mounting panel with the counter-sunk
screws (both included in delivery) to the bot-
tom plate of the UP 7BMW.
2. Connect the male connectors of the MATCH
connection cable to the amplifier (System
Connector 1 and 2).
3. Push the amplifier including the mounting
plate onto the original mounting fixture in the
vehicle.
4. Bolt the mounting plate to the original mount-
ing fixture in the vehicle again.
5. Finally connect the female connector of the
UP 7BMW connection cable (1) to the male
connector of the vehicle cable harness (2).
2
1
21