Viatom Checkme Lite Benutzerhandbuch Seite 8

Index), systolic Blood Pressure. It takes only 20 seconds to collect your vital signs before
giving results.
Using Daily Check
To start a Daily Check, follow the steps as below.
1. Tap the <Daily Check> icon in the middle of the
Main screen.
2. Choose a user from user A, user B, user C, user D.
3. Hold the device according to the instruction, keep
the device at the same level as your heart, and keep stable posture and stay calm.
Don't exert too much pressure on the ECG electrode, which may result in EMG
(electromyograph) interference. Just hold gently and ensure good contact with the
ECG electrode. Do not exert pressure on the finger that put in the SpO
fit it inside but gently to ensure good blood perfusion.
(1) Put the right forefinger into the built-in SpO
(4)
squeeze the edge of the SpO
to raise it up as shown below.
(2) Press the right thumb on the right electrode.
(3) Press the right middle finger on the back electrode.
(4) Press the left electrode to the left palm.
4. Once the device detects stable waveform, it will automatically start the
measurement. The countdown bar moves from left to right.
5. When the bar is fully filled, the device will analysis your data, and then show the
measurement result.
BP Calibration
To get blood pressure readings, this device should be calibrated by a doctor with a
traditional cuff blood pressure (BP) meter. Because of individual differences, each user
must make his/her own calibration before using Daily Check to measure or track the
blood pressure. The calibration should be performed when the user is under calm status.
To calibrate with a cuff BP meter, follow the steps as below.
1. Find a qualified traditional cuff BP meter.
2. Sit down and stay calm.
3. Place the cuff on you left arm according to instructions.
2
sensor cover, then move in upward to the left
2
6
sensor. Use the finger nail to
(1)
(2)
(3)
sensor. Just
2