Klarstein 10032041 Bedienungsanleitung Seite 14

EN
14
Important Notes
• Do not use the machine when the environmental temperature is over 35°C or below 5°C.
• Pour the water when the water tank is full and the indicator will become red. Then
put the water tank to the original place so that the machine can work again.
• Restart the machine after at least 3 minutes when it stopped in order to avoid to
destroy the compressor.
Water drainage manually
1 The compressor and motor will stop
when the water tank is full and the
red indicator light will be on.
2 Take out the water tank and then
pour the water off.
3 Put the water tank to the original place
and restart the machine (three minutes
self-protect for compressor after stop).
Water drainage continuously
1 Cut off the power.
2 Cut the three seal of continuous drainage hose.
3 Connect the water pipe of inner diaineter (thickness = 9mm*2mm) to the drain
hose)
4 Route the other end of the hose into a drain that is deeper than the water outlet.