Before First Use; Karaoke; Signal Sources And Their Connections - auna Karaoke Star 1 Bedienungsanleitung

BEFORE FIRST USE

• Select a central location for the amplifier.
• Connect the speaker wires (red & black) to the + and – terminals on the
rear panel of the amplifier.
• Connect the audio signal to the relevant sockets with the correct
polarity.
• Plug the mains lead in and switch the amplifier on once you have
checked all connections.
• Switch the audio sources on and adjust the master volume to the
required level.

KARAOKE

• Plug a mic into MIC1 or MIC2 socket on the front panel.
• Before you use the mic, make sure that it is switched off and the MIC
volume button is set to the minimum.
• Connect the microphone, switch it on and adjust slowly the volume and
the echo.
• If you don't use the unit any longer, switch the amplifier off and
disconnect it from the mains.

SIGNAL SOURCES AND THEIR CONNECTIONS

• Connect a DVD-player or a CD-player to the terminal AUDIO INPUT or
a data storage unit to the USB-interface or insert a SD- memory card in
the suitable slot or activate the BT function on your smartphone.
• Select the active signal source by pressing the INPUT button until the
desired input source is displayed.
• Use the MP3 CONTROL-function for controlling the files on a connected
data storage unit.
• If you wish to use the karaoke function of this device, insert one or two
microphones into MIC1 and MIC2. Their signals are going to the signal
output too.
EN
13