Maintenance; Optional Accessories - Makita DBN500 Bedienungsanleitung

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge and nails are removed before
attempting to perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may result.
Cleaning of magazine
When the pusher in the magazine does not move
smoothly because of dust, sand, chips or other foreign
matters, clean the magazine.
Fig.18
To remove the slide door, loosen the hex bolt on the
magazine.
Fig.19
Pull the pusher from the slide door and then remove the
stopper, sleeves and springs.
After cleaning, install the whole parts into the slide door.
To install them, take the following procedure.
1. Install the large spring into the slide door.
2. Install the parts onto the pusher in the correct
order, sleeve, small spring and then stopper.
3. Install the pusher with the other parts onto the
slide door.
NOTE:
When you pull out the pusher from the slide door,
•
the parts in the slide door may bounce out.
When you install the pusher with the other parts to
•
the slide door, make slight spaces between the
pusher and sleeves.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These accessories or attachments are recommended
•
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Nails
•
Makita genuine battery and charger
•
Safety goggles
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
10