AEG S73130KDX3 Benutzerinformation Seite 35

1 2
4. Unscrew the hinge (1) and remove
the cover plate (2).
5. Remove the support (3) and install
the cover plate and hinge on the
opposite side. Install the support on
the opposite side.
1
3
6. Unscrew and move the lower hinge
(1).
7. Move the pin to the opposite side
(2).
8. Unscrew the support (3).
9. Screw on the lower hinge and the
support on the opposite side (4, 5).
10. Tighten the pin with the adjustment
spanner supplied.
4
3
3
2
1
5
2
11. Install the handle on the opposite
side.
12. Raise the appliance and install the
ventilation grille.
13. Put the cabinet in position.
CAUTION!
Reposition, level the
appliance, wait for at least
four hours and then connect
it to the power socket.
Do a final check to make
sure that:
• All screws are tightened.
• The magnetic seal
adheres to the cabinet.
• The door opens and
closes correctly.
If the ambient temperature
is cold (i.e. in Winter), the
gasket may not fit perfectly
to the cabinet. In that case,
wait for the natural fitting of
the gasket.
In case you do not want to
carry out the above
mentioned operations,
contact the nearest
Authorised Service Centre.
The Authorised Service
specialist will carry out the
reversibility of the doors at
your cost.
ENGLISH 35