Werkseinstellungen - Datalogic Heron D130 Kurzanleitung

PEN EMULATION KONFIGURATION
Lesen Sie den Restore Default Code, um die Pen – Emulation
zu aktivieren.

WERKSEINSTELLUNGEN

USB DEFAULT SETTINGS
DATA FORMAT
code length not transmitted, character replacement disabled.
USB KEYBOARD
code delays disabled, control character emulation =
ctrl+shift+key.
: no handshaking, delay disabled, rx timeout 5 sek.,
USB COM
ack/nack disabled, FIFO enabled, serial trigger lock disabled.
Default Headers and Terminators for each USB mode:
-
USB-KBD: no header, terminator = ENTER
-
USB-KBD-ALT-MODE: no header, terminator = CR
-
USB-COM: no header, terminator = CR-LF
-
USB-IBM-TABLE TOP: not applicable
-
USB-IBM-HAND HELD: not applicable
RS232 Standard DEFAULT SETTINGS
9600 baud, no parity, 8 data bits, 1 stop bit, no handshaking,
delay disabled, rx timeout 5 sek., ack/nack disabled, FIFO
enabled, serial trigger lock disabled.
DATA FORMAT
code length not transmitted, no header, terminator = CR-LF,
character replacement disabled.
WERKSEINSTELLUNG
Ì$+$*oÎ
Ì$+CP6$-BÎ
: code identifier disabled, no field adjustment,
: USA keyboard, inter-character and inter-
: code identifier disabled, no field adjustment,
PEN