Installing The Appliance - AEG ERN3001FOW Benutzerinformation

14 www.electrolux.com
6. Install the spacer.
7. Install the door.
8. Tighten the upper pin.
Do a final check to make
sure that:
• All screws are tightened.
• The magnetic seal
• The door opens and
If the ambient temperature is
cold (i.e. in Winter), the
gasket may not fit perfectly
to the cabinet. In that case,
wait for the natural fitting of
the gasket.
In case you do not want to
carry out the above
mentioned operations,
contact the nearest
Authorised Service Centre.
The Authorised Service
specialist will carry out the
reversibility of the doors at
your cost.

8.5 Installing the appliance

CAUTION!
Make sure that the mains
cable can move freely.
1. If necessary cut the adhesive sealing
strip and then apply it to the
appliance as shown in figure.
adheres to the cabinet.
closes correctly.
x
2. Drill the unit using a Ø 2.5 mm drill
(10 mm max. penetration).
3. Fix the square fitting to the appliance.
13 mm
1
Ø 2.5 mm
3
4. Install the appliance in the niche.
5. Push the appliance in the direction of
the arrows (1) until the upper gap
cover stops against the kitchen
furniture.
x
2