Replacing The Lamp; Installation; Closing The Door - AEG ERN3001FOW Benutzerinformation

12 www.electrolux.com
Problem
Water flows on the floor.
Temperature cannot be
set.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.

7.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.

8. INSTALLATION

WARNING!
Refer to Safety chapters.
Possible cause
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The FastFreeze or Shop‐
ping Function function is
switched on.
The temperature regula‐
tor is not set correctly.
The door is not closed
correctly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been
opened often.
The FastFreeze function
is switched on.

7.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
3. If necessary, replace the defective
8.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
Solution
Attach the melting water out‐
let to the evaporative tray.
Switch off FastFreeze or
Shopping Function manually,
or wait until the function re‐
sets automatically to set the
temperature. Refer to "Fast‐
Freeze or Shopping Function
function".
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces‐
sary.
Refer to "FastFreeze func‐
tion".
to "Installation".
door gaskets. Contact the Authorised
Service Centre.