AEG ERN3001FOW Benutzerinformation Seite 11

Problem
The appliance is noisy.
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the FastFreeze,
or after changing the tem‐
perature.
Water flows inside the re‐
frigerator.
Possible cause
There is no voltage in the
mains socket.
The appliance is not sup‐
ported properly.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The FastFreeze function
is switched on.
The water drainage plug
is not correctly posi‐
tioned.
Food products are not
wrapped properly.
Temperature is set incor‐
rectly.
This is normal, no error
has occurred.
The water outlet is clog‐
ged.
Food products prevent
that water flows into the
water collector.
ENGLISH
Solution
Connect a different electrical
appliance to the mains sock‐
et. Contact a qualified elec‐
trician.
Check if the appliance
stands stable.
Close and open the door.
Contact the nearest Author‐
ised Service Centre.
Refer to "Operation" chapter.
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "FastFreeze func‐
tion".
Position the water drainage
plug in the correct way.
Wrap the food products bet‐
ter.
Refer to "Operation" chapter.
The compressor starts after
a period of time.
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
11